ELK Integration How to Setup

Programming the ELK Panel

Program your ELK controller(s) to send events automatically to the host:

  1. Enter the Installer Programming mode: Press "ELK" key + 9 (menu 9) followed by the Right arrow key. 
  2. Enter the default Installer code of 172839 when prompted. 
  3. Display should read: "01 - Bus Module Enrollment" 
  4. Use the Up arrow key to scroll to Menu 07 "07 - Global System Definitions".   Note: you can alternately jump straight there by entering 07. 
  5. When the display shows Menu 07 then you need to press the Right arrow key to enter this menu. 
  6. Us the Up arrow key to scroll to option G35.  This option needs to be set to "Yes".   To do that press the right arrow key to place the cursor under "No" and then press 1 to change it to Yes. 
  7. Press "ELK" key to move the cursor back after you changed this option to Yes. 
  8. You might want to scroll Up to review the settings for options G36, G37, G38, G39, and G40.  All of these should be set to "Yes". 
  9. To exit from the programming mode just press the " * " key. 

From Hardware Manager in IS2000, add a new ELK Driver, and then add an ELK controller.   

Set the following ELK controller properties in Hardware Manager:

Note:  If the ELK controller is to communicate via TCP/IP then, you must make sure that port 2101 is not blocked and that you have enabled the non-secure communication port using the ElkRP software's M1XEP Setup.


Integration Support

If the ELK driver can communicate successfully to the controller, then you should see the controller status screen start to update within a minute.  We do not recommend polling more than 32 ELK panels/controllers per driver.  If you wish to poll more than 32 ELK panels/controllers, then please add another ELK driver on another PC.  When the driver initially starts up, it goes out to the panel and imports the following:  Keypad descriptions, Input descriptions, Output descriptions, Area Descriptions and User names.  Once complete you should be able to see the time update in the Controller Status window for the Elk controller.


Debug Mode

To turn ON Debug Mode, set the DriverDebug property to 1 in the OS section of the Registry.  The log file will generate error messages and messages to the 'Data\Drivers\18000-X.log' file.