To access the network page of the SCP-2 Mercury controller, follow these steps: Power the Mercury controller down Flip all dip switches to the ON position and re-apply power to the controller From a browser type http://192.168.0.251 Enter the User Name:  admin Enter the Password:  password Note:  In order for…
The ACP / inBIO Advanced Access Control controller family, is the most feature rich and cost effective solution for access control.  Boasting the largest worldwide install base, these controllers are robust and adhere to open architecture standards.   The ACP / inBIO product line was built on a flexible,…
The VertX hardware platform including the Edge plus hardware devices are capable of the following pin functions: When using a combination reader that makes use of both card and pin in a single reader and the card and pin feature will be used, it is imperative that the reader’s keypad…
AXIS A1001 Network Door Controller and the built-in web based software AXIS Entry Manager is developed to meet the requirements of small to mid-sized businesses such as offices, industries and retail stores, that typically have 10 doors and basic access control needs. For installations requiring more advanced access control…
Below are the steps for setting up the First Man In scenario: Step 1: Install or Upgrade to IS2000 Version 9.4.43 or later. Step 2: Copy the this Trigger Template file to your IS2000\Data folder on the IS2000 Server.  (Click on link and then right mouse click on new window…
DMP Upgrade: Convert existing DMP cards to 26 Bit Universal Format Sell an enrollment reader that is Programmed for 26 Bits For new card they will buy Imron Cards with 37 bit format Re-Program existing Enrollment reader to Imron 37 Bit Format
The M5 Bridge Family was built to capture legacy installations of third party access control hardware. This is not a new line of Mercury controllers. It is the Authentic Mercury controller platform reshaped to fit the specific confines of Casi Micro5 enclosure used in Picture Perfect™, Secure Perfect™ and Facility…
It has come to our attention that there is a clock drift within the VertX and Edge products. In order to address this clock drift we have come up with a patch which can be loaded on VertX and Edge products running R2.2.7. Please review the Application Note the below…
• EPC-1/SCP-2 controllers are defaulted out of the factory as 192.168.0.251, with all four dip-switches on. • Perform a direct connect to the controller via cross-over cable and a PC/Laptop with IP address of 192.168.0.250.   • Launch the browser and enter the controller address 192.168.0.251.   • To login,…
Supporting 250,000 Cardholders per Controller In order to allocate enough RAM in the SCP-2, SCP-M, and/or EPC-1, you MUST first disable some of the features that take up most of the RAM.  One in particular is the number of access levels that a card holder can have per record. Copy…
The Mercury driver logs the date/time stamp according to the PC's Time Zone configuration.  You can change the PC's Time Zone setting via the operating system, or you can set the Zulu_Time property to 1 in the RemotePath\Drivers\12000.ini file under the [General] section.  Please note that it is recommended that…
Configuring the VertX IP address •  From the Host computer configure the IP address of the host computer to be 169.254.242.122 and a sub-net of 255.255.255.0. •  Connect a cross-over cable from the host computer to the VertX controller. •  From an Internet Explorer browser type http://169.254.242.121/cgi-bin/setup.cgi . NOTE:  The…
Page 1 of 2