Configuring a New EPC-1/SCP-2 Controller to Match your Network

• EPC-1/SCP-2 controllers are defaulted out of the factory as 192.168.0.251, with all four dip-switches on.

• Perform a direct connect to the controller via cross-over cable and a PC/Laptop with IP address of 192.168.0.250.  

• Launch the browser and enter the controller address 192.168.0.251.  

• To login, enter user name “admin” and password “password”.

• Click on the ‘Network’ menu item from the left.  

• Select ‘Use Static IP configuration’ and enter the correct network parameters.

• Click Accept.

• To complete the process, click ‘Apply Settings’ menu item from the left.  

• The controller will now be updated to the newly applied network settings.

• Disconnect from the controller.  Connect the controller to the network.

• Power the controller down and change all dip-switches to the off position.

• Power the controller up.

• Proceed by adding the controller via IS2000.