HID VertX

HID VertX

The VertX hardware platform including the Edge plus hardware devices are capable of the following pin functions: When using a combination reader that makes use of both card and pin in a single reader and the card and pin feature will be used, it is imperative that the reader’s keypad…
DMP Upgrade: Convert existing DMP cards to 26 Bit Universal Format Sell an enrollment reader that is Programmed for 26 Bits For new card they will buy Imron Cards with 37 bit format Re-Program existing Enrollment reader to Imron 37 Bit Format
It has come to our attention that there is a clock drift within the VertX and Edge products. In order to address this clock drift we have come up with a patch which can be loaded on VertX and Edge products running R2.2.7. Please review the Application Note the below…
Configuring the VertX IP address •  From the Host computer configure the IP address of the host computer to be 169.254.242.122 and a sub-net of 255.255.255.0. •  Connect a cross-over cable from the host computer to the VertX controller. •  From an Internet Explorer browser type http://169.254.242.121/cgi-bin/setup.cgi . NOTE:  The…
From the VertX controller's perspective, what IP address does it see the IS2000 server as?  That is the IP address that should be entered into the CS Host property for each respective controller.  Port forwarding of 4050 and 4070 may need to be enabled in the routers to achieve this.…
HID Global's Networked Access Solutions provide an open architecture, IP-enabled platform for deploying a broad range of access control systems. HID Global’s Networked Access Solutions are offered in two product flavors, EDGE® a single-door PoE-enabled controller and VertX® a traditional topology multi-door controller with downstream interface modules.  VertX/Edge Setup…
From Hardware Manager, unlock the module by clicking on the pad lock icon. Highlight one of the VertX controller’s from the Hardware tree list. Right mouse click on the controller and select Controller Commands, Reload firmware.   Any controllers installed under the driver will be flashed.  Please note it takes…
Alarm message for VertX: A non-numeric Data in Pin Code for VertX This message is accurately stating the issue. The software doesn't allow you to type in non-numeric values, but you can fool it by doing a copy and paste using the right click menu options.
VertX will ONLY communicate to 1 PC at a time.  VertX will ONLY communicate to the IP address of the PC that has been pre-programmed into its CS/Host IP property. For IS100 (Web Browser product), this will automatically program the CS/Host property of the PC attempting to make the connection,…
LAN 1) Browser trust issue. 2) Make sure ports 4050/4070 are open on the host PC. WAN 1) Program the CS Host IP address in the Network Configuration Page. 2) Append the ?WAN=1 option to the address bar.
http://xxx.xx.x.xxx/cgi-bin/setup.cgi