Triggers and Macros

Triggers and Macros

In order to configure Global Input to Output Linking, you must create a text file in notepad and place it within the Remotepath with the following filename: "ControlPoint<Driver ID>.ini" The contents of the file should contain the Monitor Point that triggers the relay as the section header in brackets, followed…
Trigger Definitions Description:  Text field to describe what the Trigger does. Events:  The event that will trigger the Macro. Address:  The specific address for where the Event occurred.  Based on the Event, you can select (ALL) for addresses in the controller or a specific address. Trigger Code:  A Trigger Code…
Drive Gate Settings Input Supervision for input 1: 0 normally closed Input Supervision for input 2: 1 normally open Note: If input 1 and/or input 2 are red, in the hardware properties, then check wiringDefault reader mode: Card Only (for both readers) Door Held Time, Door Contact Input 2: 50 seconds Output 1 Pulse…
*#Access Granted by reader and Accessgroup* L(1)=[interfaceid=0][reader=0][accessgroup=2]E(2,20) L(1)=[\]S(2) G(1)=S(1)&L(1) *Use the UniqueID for the credential from the grant at any door:* TCP("HOST","PORT","MESSAGE") = ([uniqueid=3](E(2,20))) *Though depending on what type of "different TCP Strings" you can use some of the parameters used as filters in the message as well:* TCP("HOST","PORT","Grant Access…