Bosch DX4020  DX4020 Connection – RPS Flip the dip switches 1,2,3 to the down position. The remaining dip switches should be in the up position. Power down the device. Reapply power to the device. From the command prompt type telnet xxx.xxx.xxx.xxx 9999 (where xxx.xxx.xxx.xxx is the IP address of the…
Radionics® PC9000 Replacement PC9000 vs IS2000   Help and Training  Bosch IS2000 Setup    Adding the Bosch G Series in IS2000   Adding Bosch Credentials in IS2000   IS2000-  G Series Training Curriculum   Supported Firmware GV3 8.11+ and everything newer GV4 v1.xx.xx GV4 v2.xx  (Mode 1)    Mode 1 Maximums D7212GV3 4…
  Please make sure that you've upgraded to Version 9.4.57 or above. Navigate to Hardware Manager and Unlock the module. Add a new ‘ZK Video Driver’ under the ‘DVR/NVR Video Drivers’ category of the ‘New Driver’ dialog window. Add a controller and then add a sub-controller for the newly added…
Capturing a Signature Click on the Access menu and select Personnel Manager. Unlock the pad lock to allow editing of the Personnel Manager module. Click on the ID Badging tab located in Personnel Manager. Highlight the personnel record for the card holder whom the signature will be associated with. The…
DMP Upgrade: Convert existing DMP cards to 26 Bit Universal Format Sell an enrollment reader that is Programmed for 26 Bits For new card they will buy Imron Cards with 37 bit format Re-Program existing Enrollment reader to Imron 37 Bit Format
RF interference can affect the Wiegand signal returning a System Kit on the reader cable.... Use a Toriod Choke Core around the wire going back to the Reader terminal block. Chock goes nearest to the door/reader.  Example: Radio Shack part # 273-104 (2-pack) for $8.39. Diodes are provided with each…
Even if the Access Level has no readers/groups assigned, the record assumes Region 1 and downloads to those controllers but won't give access unless if the reader is in the Access Level.Panels could have different card counts because they could have different personnel loaded based on the access levels.Perform a…
Hardware Manager Cascade Settings to Child Node Each Hardware level located in the Hardware Tree can be configured with System Partitioning.  When configuration has been completed, the operator can choose to propagate the changes automatically to all sub-devices or only to the device in which the changes were made. If…
The M5 Bridge Family was built to capture legacy installations of third party access control hardware. This is not a new line of Mercury controllers. It is the Authentic Mercury controller platform reshaped to fit the specific confines of Casi Micro5 enclosure used in Picture Perfect™, Secure Perfect™ and Facility…
Configuring the CCTV Matrix Switcher   It is often desired to have a matrix switcher display cameras based on alarms occurring in IS2000.  This can be accomplished by configuring IS2000 to output ASCII strings via the serial port.This is accomplished by creating / modifying the camera1.ini file located on the…
The client workstations will freeze up if they cannot access the Data folder on the Server.  Typically a mapped drive letter is used to represent the Data folder on the server, and at times this can get unmapped when a Windows operator logs off of the PC.  If you are…
It has come to our attention that there is a clock drift within the VertX and Edge products. In order to address this clock drift we have come up with a patch which can be loaded on VertX and Edge products running R2.2.7. Please review the Application Note the below…